Tabla de contenido
Publicidad
Less than 3 minutes of mixing are enough to blend liquids for most of
the recipes
For adding ingredients while blending, remove the middle cap from the
lid and add the ingredients through the feeder hole. Beware of the risk
of spatter.
CAUTION: After running one cycle in the blender for the maximum
processing time, let the blender rest for 1 minute before operating it
again.
After using the blender for a maximum of three cycles, stop the appliance
and leave to cool to ambient temperature (takes about 2 hours).
The appliance is equipped with overload protection. This prevents the
motor from being damaged by overloading.
If the appliance switches off during operation, proceed as follows :
unplug and leave to cool down for approx.15-20 minutes.
Reconnect the appliance to the power supply and resume blending.
After approx 3 minutes without use, your appliance will start a stand by
mode. To switch on you appliance, press the Start/ Stop button (G)
ROUGH CHOPPING SMALL QUANTITIES
Accessories used: assembled chopper
Chop in a few seconds by pulsing: peanuts, almonds etc.
Model 1600w: quantity / max time: 140g peanuts/8s or 150g almonds/8s
4
Publicidad
Tabla de contenido
