AmazonBasics B07J4VK742 Manual Del Usuario página 12

Juego de manillas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Step 10: Mark Outline of Strikes
• Measure only one-half of the door's thickness starting from the door stop and vertically mark
the center of the drill point center for the strike.
• Place the strikes in position and mark the outline of the strike plates.
Step 11: Drill Holes and Install Strikes
• Drill a 1" (25.4 mm) hole into the door jamb. Caution: To ensure proper lockset function, holes in
the door jamb must be drilled 1" (25.4 mm) deep.
• Chisel an outline for the strike plates that is 1/16" (1.5 mm) deep, or until the plates are flush
with the door jamb.
• Install the strike plates and secure with wood screws.
12
Mark outline of
strike plates
Door stop
Vertical centerline
of jamb
Drill point center
for strike

Publicidad

Tabla de contenido
loading

Tabla de contenido