August MS430 Manual Del Usuario página 4

5 2 Bluetooth Connection .
When switched on, the MS430 will enter reconnection
mode and will automatically connect to any previously
known device. If no such device is found, it will enter
pairing mode and the status LED will flash blue quickly.
To clear all previously known devices, turn off the MS430,
then press and hold the Multifunction Dial for 10 seconds.
For mobile phones and tablets
1. Scan for available Bluetooth devices on your mobile
phone or tablet.
2. Select 'MS430' from the available devices and confirm
the connection. If a pin code is requested, please enter
the code '0000'.
3. Once successfully paired, the status LED will flash blue slowly.
For computers
1. Enable the Bluetooth function on your computer.
2. Select 'Devices and Printers' from the Control Panel
and click 'Add a Device'.
3. Select 'MS430' from the available devices. The driver
will be installed automatically. If a pin code is
requested, please enter the code '0000'.
4. Once successfully paired, the status LED will flash blue
slowly.
5.3 Line-In
Plug the 3.5mm audio cable into the audio socket. The
MS430 will enter line-in mode automatically. In line-in mode,
the status LED will light blue.
Unplugging the audio cable will automatically return the
MS430 to Bluetooth mode.
-4-
5.4 Multifunction Dial
To switch on the MS430, press and hold the Multifunction
Dial for 2 seconds.
Operation
Press
Press and hold
Double Press
Turn
6 Charging .
To charge the MS430, connect is to a powered USB port
using the USB charging cable provided. While charging, the
status LED will light red. It will turn off once the battery is
fully charged. A full charge will take approximatively 3 hours
depending on the power input.
Function
Play / Pause; Pick up / Hang up a call;
Mute / Unmute (line-in mode)
Power on / off
Last Number Re-dial
Volume Control
-5-