Velleman HQ-Power VDPDMXC136 Manual De Instrucciones página 3

13. Master fader
14. Audio level fader: to adjust the music sensitivity
15. Speed fader : to adjust the chase speed
16. Stand by : disable all outputs by pressing this button (chaser programme will continue to run
but no output is generated)
17. Full on : sets the output of all channels to 100%. Release the button to return to the initial
settings.
18. TAP SYNC : press this button twice to define the rhythm of the music. Makes the chaser
move to the beat of the music.
19. Built-in microphone
b) Connections
The manufacturer is not responsible for damage caused by improper connections. All
connections are made on the back panel of the device.
Connect the supplied adapter with the DC jack and connect the other end with a mains outlet.
Plug the XLR cable into the VDPDMXC136 and connect the other end with the first device to be
controlled. Activate the device with the power switch.
You can also plug the 8-pin DIN connector into the device and connect the other end with the
dimmer / switching pack.
Use the RCA/cinch connector for external audio input if needed.
5. Operating Instructions
Activate the device with the ON/OFF switch. Choose the desired mode with the MODE SELECT
button. Press the button repeatedly to select the following modes (in this order) : Hold Dimmer
→ Hold Sound → Prog. Sound → Prog. Speed → Auto Sound → Auto Speed → Memory →
Hold Dimmer, etc.
1) Hold Dimmer : All channels are controlled by their respective channel faders.
2) Hold Sound : All channels are controlled by their respective channel faders and the audio
level fader
3) Prog. Sound : The chase is music-controlled but the programme is selected through the
PROG SELECT button (42 possible programmes)
4) Prog. Speed : The chase is speed-controlled and the speed is adjusted with the speed
fader. The programme can be selected through the PROG SELECT button
(42 possible programs)
5) Auto Sound : The chase is music-controlled. Each programme is executed 8 times before
the device switches to the next programme number. Read the number of the
current programme on the LCD. The PROG SELECT button is inactive.
6) Auto Speed : The chase is speed-controlled and the speed is adjusted with the speed
fader. Each programme is executed 8 times before the device switches to the
next programme number. Read the number of the current programme on the
LCD. The PROG SELECT button is inactive.
7) Memory : You can create your own 32-step programme :
- Hold PROG SELECT
- Press STAND BY several times to activate different modes : the programming mode
(PA), the manual mode (ST), the auto sound mode (AS) and the auto speed mode (AP).
- Release the PROG SELECT button to confirm the selected mode.
VDPDMXC136 3 VELLEMAN