Velleman HQ-Power VDPDMXC136 Manual De Instrucciones página 4

8) PR-mode
- Slide the master fader to the top and put the channel faders in the desired position.
- Press PROG SELECT : the LED display shows 01, meaning that step 1 has been stored.
- Set the channel faders to the next position for step 2.
- Press PROG SELECT : the LED display shows 02, meaning that step 2 has been stored.
- Repeat the same process for all 32 steps and exit the programming mode by pressing
MODE SELECT
- Select the MEMORY mode and adjust the speed with the speed fader.
The memory can be called up and played in one of three modes (see below).
- Hold the PROG SELECT button
- Press STANDBY to display the 3 modes : rate sound (AS), rate speed (AP) or step (ST)
- Release PROG SELECT to confirm the selected mode.
a) Step Mode (ST) : Press the PROG SELECT button repeatedly to run the
b) Rate Sound (AS) : Scenes are music-controlled. Adjust the music sensitivity
c) Rate Speed (AP) : Scenes are speed-controlled. Adjust the chase speed with
9) Flash Mode
10) Standby Function
11) TAP SYNC
12) Backup
13) Internal/external source : Two modes can be activated when the device is ON : "I" is
To switch modes :
• turn off the device
• hold the PROG SELECT button
• turn on the device
• Press MODE SELECT to change the mode
• Release both buttons
VDPDMXC136
scenes step by step.
with the AUDIO LEVEL fader.
the SPEED fader.
: Set the channel output to maximum by pressing the flash button of
a channel.
: Press this button to bring the output of all channels to zero.
Programmes will continue to run but no output will be generated.
The only functions still active are the channel flash buttons and the
full-on button. Press STAND BY again to exit the standby mode.
: Use this button to manually set the chase speed to the beat of the
music. Press this button twice to define the rhythm of the music.
Makes the chaser run along to the beat of the music.
: The device can remember the stored programme for ± 1 month.
Make sure to activate the device at least one hour each month to
retain the stored values.
displayed if the music is controlled internally through the built-in
microphone. "E" is displayed if the music is controlled externally
through the RCA connector at the back of the device.
4 VELLEMAN