Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed:
10 mm wrench
■
Flat-blade screwdriver
■
Parts Supplied:
Key (2)
■
Top mat (1)
■
Drawer model: Drawer liners (5)
■
Cabinet model: Tray liner (1)
L-shaped bumpers (2)
■
M6 x 12 mm Phillips-head
■
screws (8)
Cabinet Use Requirements
Intended for use in a garage.
■
Maximum weight limit is 65 lbs (29 kg) per drawer/shelf.
■
Maximum weight limit is 1,400 lbs (635 kg) per cabinet.
■
Unpack the Cabinet
NOTE: Keep the packing materials to cushion the cabinet during
assembly and then dispose of/recycle all packaging materials.
1. Open the doors or drawers.
2. Verify contents. See "Parts Supplied."
ASSEMBLY INSTRUCTIONS
Phillips screwdriver
■
M6 Shoulder washers (8)
■
Rigid casters (2)
■
Swivel casters (2)
■
M6 Self-locking nuts (16)
■
M6 x 14 mm
■
Carriage-head bolts (16)
Install the Bumpers
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
Close and lock the doors or drawers. Remove the key.
NOTE: The drawers must be pushed in completely to lock.
Remove the top mat from the cabinet. Using two or more people,
turn the cabinet upside down.
1.
Install the bumpers
A. Bumper
Attach the bumpers to the front corners using four shoulder
washers (F2) and four Phillips-head screws (F3) for each bumper.
NOTE: To keep from stripping the screws, do not overtighten.
Using a Phillips screwdriver, tighten all the screws.
A
F2
F3
F2. Shoulder washer
F3. Phillips-head screw
3