EN
OPERATING EXAMPLE.
MAINTENANCE (THIS COMPRESSOR DOES NOT NEED OIL).
Before performing maintenance, make sure the compressor is switched off and
disconnected from the power source.
• This compressor is self-lubricating, but it is not necessary to add oil.
• At the end of the work, empty the condensation of the air in the tank with the trap (10).
• Check for any unusual noise or vibration.
• Keep the air inlet filter clean and unobstructed, to avoid limiting air intake into the compressor.
• In case of transport and / or storage, the compressor must not expose to temperatures outside
the range: + 5ºC to + 40ºC.
31