Preparing For Use - Sinbo SHC 4344 Manual Del Usuario

PREPARING FOR USE

store the remainder the charging 4(220V50Hz/60Hz).In order to charge the
appliance it should be placed in the battery charging stand 4 so that the
control lamp 5 lights up.While the appliance is being charged,the switch
must be set at"0"(the "0"must be visible).A charging period of 16hours is
required before initial use.Take care to keep the charging contacts 3 clean
as soiled charging contacts can interfere with the charging process
Overcharging of the appliance is not possible.
3. After charging the appliance is ready for use.It can be used with or without
the clip-on comb attachment.To attach the clip-on comb attachment,slide
it onto the cutting head1 until it clicks into postion.The appliacne must be
switched off while the clip-on comb attachment is being attached or remove.
4. The clip-on comb attachment is easily adjustable .Simply slide it up or
down the cutting head1.The hair can be cut to 4different lenghts ranging
from approximately 3mm to 6mm.The postion of the clip-on comb attachment
on the cutting head determines the length of the haircut.
5. After using the appliance,switch it off and replace it in the battery charging
stand 4 to be recharged-the control lamp 5 must light up.In order to retain
the load capacity of the storage battery we recommend to use the storage
battery until it is empty before reloading.
REPLACING THE CUTTING HEAD
Switch the appliance off the replaing the cutting head!
If the performance of the appliance deteriorates after extended use,despite
the regular cleaning and maintenance ,the cutting head1 should be replaced
(the cutting head can be ordered as a spare part form the Service
Department).First remove the hexagonal screw on the cutting head 1 by means
of the hexagonal spanner attached to the underside of the charging stand 4
in the direction"__"and remove the old cutting head (Fig.2.)Important:First
remove the screw,then remove the cutting head!Place the new cutting head
on the main body of the appliance screw on place with the spanner (direction"+").
- 9 -