Using The Hair Clipper - Panasonic ER1610 Instrucciones De Operación

Charging without the charging stand

1. Press the OFF/ON switch to turn off the
power, and insert the appliance plug into
the clipper.
2. Plug in the adaptor into a household
outlet.
AC operation

If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it even if the battery
capacity is low.
•
If the clipper does not operate, charge the clipper for
approximately 1 minute.
•
Be careful not to discharge the battery completely with the power
left turned on. It results in shortening the battery life.
4
ER1610_EU.indb 4
Using the hair clipper
Turn the dial clockwise or counterclockwise to
adjust the moving blade back and forth to get the
desired height. Adjustable in 5 stages from 0.8 mm
to .0 mm in 0.3 mm steps without attachments.
Using the comb attachments

1
1
Select the trimming heights
indicated on the insides and
sides of the attachments.
2
2
Set the dial to "0.8" and then
mount the attachment to the
clipper as illustrated.
Removing the attachment from the clipper
Slide one side of the attachment off the
mounting in direction indicated with the arrow.
0.8
0.8
2008/04/23 14:26:43