Charging The Clipper; Using The Clipper - Panasonic ER-GP30 Instrucciones De Operación

Charging the clipper

• Make sure that the clipper is turned off.
1
1
Insert the appliance plug
into the clipper.
2
2
Plug in the adaptor into a
household outlet.
• Charging is completed after
approx. 8 hours.
• Check the charge indicator lamp
( ) glows.
3
3
Disconnect the adaptor from the household
outlet when charging is complete.
(for safety and to reduce energy usage)
• The charge indicator lamp (
charging is complete. There is no indication to show that
"charging is complete".
Notes
• If there is crackling noise on radios or other devices while
charging, charge the clipper using a different household outlet.
• When the appliance is not used for 6 months or more, the battery
will weaken (leak battery fluid, etc.). Fully charge the battery
once every 6 months.
• When charging the clipper for the first time or when it has not
been in use for more than 6 months, the lamp on the main body
may not glow for a few minutes, or the operating time may
shorten. Please charge it for more than 16 hours in such cases.
• Recommended ambient temperature for charging is 0 °C – 35 °C.
Battery performance may decrease outside of the recommended
temperature.
• 1 full charge will provide approximately 40 minutes of continuous
operation.
10
ER-GP30_EU.indb 10
• You can charge the battery before it is completely discharged.
2
2
If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly or
1
1
• The battery will be discharged, even with the AC operation.
• Make sure that the clipper is turned off.
• The appliance may not operate in an ambient temperature lower
) continues to glow after
1
2
Mounting the attachment
Align the front of the attachment
with the blade (1), and then
press the attachment against the
main body (2).
However, it is recommended to charge when the battery is
completely discharged. The battery life depends strongly on
factors such as how it is used and stored.
AC operation
stop, even with the AC operation. In this case, charge the battery
for 3 minutes or more.

Using the clipper

than approximately 0 °C.
1
Select the trimming heights indicated on the
insides and sides of the attachments.
2
Slide the power switch on the main body to the
" " position to turn on the clipper.
Removing and mounting the comb attachments
2016/05/06 17:51:45