Team kalorik TKG SFC 1002 Manual De Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
Fax +32 2 359 95 50
4)
Place the blue microfiber floor pad or the white cotton floor pad on the floor with the
Velcro loop strips facing
nozzle onto the floor pad.
NOTE: Do not operate the steam cleaner without a cloth pad in place.
5)
Push the water tank release lock upwards to take out the water tank, open the water tank
cap, fill it with cool tap water but do not exceed the maximum fill line, tighten the cap
and replace the water tank back to the unit. To do so, push the water tank release lock
upwards and make sure that the water tank is put back in place correctly, then let go of
the water tank release lock and press until it clicks into place.
NOTE: Always make sure that the steamer is turned off and unplugged before filling the
water tank.
6)
Wrap the power cord around the upper and lower cord wrap hooks for better use of the
steamer when moving and cleaning, and plug into a grounded outlet. The green OFF/0
indicator lamp of the switch will illuminate when the steamer is plugged in.
NOTE: It is recommended that no other high wattage appliance is operated on the same
circuit to avoid a circuit overload.
7)
Holding the floor nozzle flat on the floor with your foot, unlock it from its parking position by
tilting the steamer handle backwards until you reach a comfortable angle.
8)
Press the pushbutton switch once for a low steam output or twice for a high steam output.
A red (low steam output) or blue (high steam output) indicator lamp will flash to indicate
that the appliance is heating up and become steady when the necessary temperature is
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
13
Assembly page 13/76
upwards and set the floor
TKG SFC 1002 - 120725

Publicidad

Tabla de contenido
loading

Tabla de contenido