Short Cord Instructions; Using The Oven - Team International TEAM OTK 1 NB Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Fax +32 2 359 95 50
Immediately unplug the appliance if a crack appears and make sure it is controlled by a
qualified competent electrician.
Your appliance must never be switched on through an external timer or any kind of
separate remote control system.
Competent qualified service: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this service.

SHORT CORD INSTRUCTIONS

A short power supply cord is provided to reduce the risk resulting from becoming
entangled in, or tripping over a longer cord. Extension cords may be used if care is
exercised in their use. Please pay attention to the following:
The diameter of the extension cord must correspond to the one of the power cord of
the appliance, in other words, it must be suitable for at least 16 ampere. Extension
cords for a lower amperage could overheat.
The longer cord should be arranged so that it will not drape over the counter top or
table, top where it can be pulled on by children or tripped over.
BEFORE USE
Unpack the appliance and accessories, then wash and wipe these accessories.
It is normal if some smoke or smell emanates from the appliance when using it for the first
time. Therefore, we advise you to use your appliance empty once before the first use. If
you want to use the oven, put its switches in
the temperature knob to the maximum position (250) for about 10 minutes. This way, the
invisible protective coating of the heating elements will burned. If you want to use the
cooking plates, preheat them during 10 minutes by turning their temperature knob to the
maximum position.
Just like with a traditional cooker, the functions of this appliance can be used individually (thus
oven only or cooking plates only) but you can also use both functions simultaneously.

USING THE OVEN

Operation
When using for the first time, clean the surface of the tray with a damp cloth and wipe dry.
Then grease the tray with butter, margarine or cooking oil.
Plug the unit into the power supply socket.
To operate the oven, use its two switches situated on the lower part of the control panel
(see picture page 2).
Settings:
Upper switch
0
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
and
Lower switch
0
9
Assembly page 9/36
position and put the turn
Function
Grill
Oven
Grill & Oven
TEAM OTK 1 NB- 070710

Publicidad

Tabla de contenido
loading

Tabla de contenido