Connections To Be Made - Axxess HDCC-02 Instrucciones De Instalación

Connections to be made

From the HdCC-02 harness to the aftermarket radio
(a) Main harness:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn-on wire (if applicable).
Note: This wire must be connected to hear sound from the factory amplifier.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
(b) 16-pin harness:
• Connect the orange/White wire to the illumination wire (if the aftermarket
radio has no illumination wire, tape off and disregard this wire).
The following (3) wires are for aftermarket multimedia/navigation radios that
provide these wires:
• Connect the Light Green wire to the parking brake wire (if applicable).
HDCC-02
Connections to be made
• Connect the Blue/Pink wire to the speed sense wire (if applicable).
• Connect the Green/Purple wire to the reverse wire (if applicable).
• Connect the Yellow RCA jack to the backup camera input (if applicable).
Note: This RCA jack is used to retain the backup camera as well as the
LaneWatch camera.
• Connect the White and Red RCA jacks to the audio AUX-IN jacks (if applicable).
(c) 12-pin pre-wired aSWC-1 harness:
• This harness is to be used in along with the optional ASWC-1 (not included)
to retain steering wheel audio controls. If the ASWC-1 is not being used,
disregard this harness. If it will be used, please refer to the ASWC-1
instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Installing the HDCC-02
With the key in the off position:
• Connect the 22-pin connector of the HDCC-02 harness, into the
HDDC-02 interface.
• Connect the (2) 24-pin, 12-pin, and 20-pin connectors of the HDCC-02 harness
into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
2