Team kalorik TKG BLS 1000 Manual De Instrucciones página 8

Fax +32 2 359 95 50
The appliance is designed for the preparation of small quantities of food, which have to
be consumed rather quickly. It is not designed for the preparation of large quantities at
once.
Do not touch the blades while the appliance is operating and do not try to block their
movement in any way.
Do not use the appliance without any food in it.
Competent qualified electrician: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not intended for professional use. You should follow the requested breaks.
Failure to follow this instruction carefully may result in damage to the motor. Please refer to the
rating label for the maximum continuous usage time (KB xx min where xx is the maximum usage
time). The breaks should last at least 10 minutes.
BE CAREFUL!
Your appliance is fitted with a security device on the pouring jug allowing the functioning of
the appliance only when the jug and its lid are correctly placed on the motor base. If those
conditions are met and the appliance does not start, call your after sales service.
MOUNTING OF THE BLENDER AND USE
• Screw the tap onto the measuring jug. Make sure that it is well screwed on (i.e. until it
cannot go any further) and that the pouring opening is directed downward (before
screwing the tap on, make sure that the sealing gasket is in place).
• Place the measuring jug onto the base in such a way that the tap enters into the notch on
the front side of the appliance.
• Fill the pouring jug with the chosen ingredients.
• Put the lid on the pouring jug. Close the feeding hole of the lid with the cap. Make sure
the two small lugs of the cap enter into the two small slots of the lid and turn the cap
clockwise to lock it into place.
• Plug in the appliance.
• Select the speed that is most suitable for the ingredients you want to process.
• The position "P" (Pulse) is particular because the knob has to be held manually. If you
release it, the appliance stops. This position is generally used to crush ice in order to avoid
damages to the blades, but it can also be used to complete the mixing.
• Press button 1 (minimal speed) for mainly liquid ingredients.
• Press button 2 (maximum speed) for combinations of liquid and solid ingredients.
• It is also possible to add liquids or other ingredients anytime without stopping the
appliance. You only have to remove the cap which closes the feeding opening by turning
it anticlockwise and lifting it straight up.
• Once you have finished the preparation, stop the appliance (button 0) and unplug the
appliance.
• To serve the mixture, put a glass under the tap and then lift the handle of the tap carefully.
To stop the flow, let go of the handle.
• A plastic mixing spoon is delivered with your appliance. If the mixture does not come out
of the tap anymore although the jug is not empty, use the mixing spoon to stir the bottom
of the mixture.
• Remove the lid.
• Caution: your appliance is not designed to mix hot preparations and the glass bowl could
break otherwise. If nevertheless you wish to prepare hot drinks or soups, let the whole cool
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/36
TKG BLS 1000 - 100116