General Information; Wall-Mounted Bracket - Carrier NTC-IR2 Manual De Instalación

NTC - IR2

General information

The remote control works only with hydronic units. For instal-
lation instructions of this unit, refer to the relevant manuals.
The operating setting to the unit are sent by the remote control
through an infrared ray.
The emitter is placed on top of the remote control just over the dis-
play (H).
For this reason, the remote control must be directed towards the
unit before sending any message and care must be taken that no
obstructions are between the remote control and the unit.
A small black arrow on the display left side indicates that the mes-
sage has been correctly sent.
An acoustical sound (beep) indicates that the message has been
correctly received by the unit.
• For trouble-free installation, which should be carried out by a
qualifi ed installer.

Wall-mounted bracket

GB - 4
• Follow all current national safety code requirements.
• After installation thoroughly test the system operation and
explain all system functions to the owner.
• Leave this manual with the owner for consultation during future
periodic maintenance.
• Dispose of packaging material in accordance with local
requirements.
• The manufacturer denies any responsibility and warranty shall
be void if these installation instructions are not observed.
• Inspect equipment for damage due to improper transportation
or handling: fi le an immediate claim with the shipping
company. Do not install or use damaged units.
• In case of any malfunctioning turn the unit off, disconnect the
mains power supply and contact a qualifi ed service engineer.
25 mm
0,984 in