English - Philips HD 4860/00 Manual De Instrucciones

English

To operate the appliance, plug the toaster into the
mains socket and slide the switch downwards.
Please note: The switch will only stay in the down
position if the appliance is connected to the
mains!
Important
• Attention: The toaster gets hot during
use.
Avoid touching the metal parts.
• If a slice of bread becomes trapped inside
the toaster:
- remove the plug from the mains socket;
- then remove the trapped slice carefully
from the toaster.
Take care not to damage the heating
elements whilst removing the bread.
Never use a metal object for this purpose.
• Bread may burn. Therefore, toasters must
not be used near or below curtains or
other combustible material. They must be
watched.
• Do not place any objects or heat-up buns
directly on top of the toaster as this could
lead to damage.
• When cleaning the toaster:
- First remove the plug from the mains
socket.
- Never immerse the toaster in water.
Wipe it clean with a damp cloth.
• If the mains cord of this appliance is
damaged, it must be replaced by Philips
or their service representative, as special
tools and/or parts are required.
For type HD 4865 only:
• Do not place the dust cover on top of the
toaster when the appliance is switched
on or when it is still hot as this could lead
to damage.
• If you wish to heat up buns, rolls or
croissants on the rack on top of the
toaster, press button
You need not set the browning knob nor
press another button.
± ±
.
Operation (see illustrations):
Your toaster has an extra deep toast chamber.
This enables you to toast high-sized slices just as
perfectly as smaller ones.
- Insert one or two slices of bread (fig. 1). When
inserting only one slice, place it in the middle of
the slot.
- Before switching on, select the degree of
browning (fig. 2).
• Select a lower position (i.e. 1 or 2) for light
browning, for toasting only one slice or for dry
bread.
• For medium browning set the browning
selector to position 2-5.
Depending on the type of bread, fine-tuning of
the browning setting may be required to obtain
optimum results.
• Select a higher position (i.e. 5-7) for darker
browning.
For type HD 4860 only: Select a higher position
(i.e. 5-7) for frozen bread.
(When toasting a series of slices, no re-
adjustment is required.)
• To reheat cooled-off toast set the browning
selector to position
- Switching on. The slices are lowered into the
toaster by sliding the slide switch downwards.
The light integrated in button
(fig. 4).
- When ready, the toast pops up automatically
(fig. 5) and the toaster switches off the heating
elements. The light integrated in button
off.
• If necessary, you can move the slide switch
upwards a little further (until it stops) (fig. 6).
This can be helpful when removing smaller
slices of bread.
• You can interrupt the process of toasting by
pressing button
The slide switch is automatically released and
the light integrated in button
• Removing crumbs from the toaster:
First remove the mains plug from the wall
socket (fig. 8).
Pull out the crumb tray (fig. 9).
Do not shake the appliance upside down to
remove the crumbs.
• After use, the mains cord can be wound up for
storage (fig. 10).
4
Ø Ø
(fig. 3).
Å Å
comes on
Å Å
(fig. 7).
Å Å
goes off.
Å Å
goes