Dorel Maxi-Cosi Tinca Instrucciones De Uso página 46

EN
A - Carrying handle
B - Sun canopy
C - Push button for carrying handle
adjustment (L+R)
D - Belt hooks for lap part of belt (L+R)
E - Harness adjuster button
F - Instruction manual storage
G - Harness belt tensioner strap
H - Belt buckle with belt pad
I - Cover
J - Newborn inlay
K - Stroller release buttons (L+R)
L - Headrest
M1 - Belt hook for shoulder part of belt
M2 - Mounting bars for base
SAFETY
The car seat is developed for an intensive use
of approximately 6 years.
Tinca car use
• Only use a forward-facing seat that is fitted
with a 3-point safety belt that complies with
the ECE R16 standard.
• Make sure the car safety belt buckle runs in a
straight line and stays below the belt hook of
the car seat.
• The car safety belt must be threaded
tight along all blue markings. For a proper
installation, check the instruction in this
manual and the sticker on the side of the
car seat.
I I
46 46 Tinca I Maxi-Cosi Tinca I Maxi-Cosi
WARNING:
Install the car seat only rearward facing in the
car on a forward facing vehicle seat.
Tinca and your baby
• Make sure you can fit no more than one
finger between the harness and your baby
(1cm). If there is more space than 1 cm, tighten
the harness belt further.
• Only use the baby-hugg inlay of the Tinca
until your baby exceeds the 60 cm length limit.
Afterwards remove the baby-hugg inlay from
the Tinca.
WARNING:
• Never place the car seat on an elevated
surface (such as a table or chair).
• In order to prevent the car seat from tipping
over during carrying, check if the carrying
handle is locked in place in carrying position
(A1).
• When Tinca is installed on a stroller, always
make sure to use approved car seat adapters
and to secure Tinca correctly.
Care
The cover, inlay, belt pads and sun canopy of
the car seat can be removed for washing. The
front baleen of the sun canopy needs to be
removed before washing.