J.P. SELECTA ST DRY PV 12 Manual De Instrucciones página 43

[Details] NV bit image is a bit image defined in non‐volatile memory by FS q
and printed by FS p.
This command is not effective when the specified NV bit image has not
been defined.
In standard mode, this command is effective only when there is no data in the
print buffer.
This command is not affected by print modes, except upside‐down
printing mode and justification mode.
This command feeds dots (for the height n of the NV bit image) in normal and
double‐width modes, and (for the height
double‐height and quadruple modes, regardless of the line spacing specified by
ESC 2 or ESC 3.
After printing the bit image, this command sets the print position to the
beginning of the line and processes the data that follows as normal data.
3.29【Print raster bit image】
[Format] ASCII
Hex
Decim l 29
[Description] Select raster bit‐image mode.
m= 0, Vertical Dot Density ： 203.2dpi; Horizontal Dot Density： 203.2dpi(dpi:
dots per 25.4 mm {1"})
xl, xH select the number of data bytes (xL+xH*256) in the horizontal
direction，0≤xL≤48，xH=0；yL, yH select the number of data bits (yL+yH*256)
in the vertical direction, 0≤yL≤255, 0≤yH≤8, 1≤(yL+yH*256)≤2303；
0≤d≤255，k =(xL+xH*256)*(yL+yH*256)(k≠0)
The d indicates the definition data. In data (d) a 1 bit specifies a dot to be
printed and a 0 bit specifies a dot not to be printed.
The raster bit‐image begin print from left (exceed the maximum printable
area), the position is not affected by the print command.
[Example] xL+xH*256=64
GS v 0
1D 76 30 m
a 118 48 m
2 of the NV bit image) in
n 
m xL xH yL yH d1...dk
xL xH yL yH d1...dk
xL xH yL yH d1...dk
；
43