Technical Data; Safety Recommendations - YATO YT-55560 Manual De Instrucciones

TECHNICAL DATA

Index Load carrying capacity [in thousands kg]
YT-55560 0,6
YT-55561
YT-55562
DESCRIPTION OF THE MACHINE
The workshop crane has been designed to be used for tasks implying lifting significant weights. It must not be used as a
permanent support element. A correct, reliable and safe functioning of the device depends on its adequate operation, so:
Before you commence work with the tool, read the operating manual thoroughly and keep it for future reference.
The supplier shall not be held responsible for any damage and injuries caused due to using the tool for purposes it has not been
designed for, failure to observe safety recommendations and the recommendations indicated within this manual. Using the device
for tasks which do not comply with the purpose it has been designed for shall also cancel the guarantee rights the user is entitled
to.

SAFETY RECOMMENDATIONS

The crane is a hydraulic device working under significant loads. During work it is required to observe basic safety
principles.
Before you start work, read the operating manual and keep it for future reference.
Do not ever exceed the maximum load of the crane.
It is prohibited to use the device to lift people and animals.
The crane has been designed exclusively for the purpose of lifting, and must not be used for other purposes. It is required to use
additional safety devices (e.g. racks) to support the lifted object, before work under it may commence.
In case of lifting vehicles it is necessary to block the wheels of the base of the crane. This will permit to avoid unexpected move-
ments of the crane while lifting loads.
Do not leave a lifted load unattended. Do net permit children and those who have not been trained in operation of the device to
enter the working area.
Do not wear loose clothes and jewellery. Gather long hair.
Use personal protection means.
The crane must be placed on an even, flat, hard and stable surface.
The crane must be placed over the device to be lifted so that the hook is over the centre of gravity of the load. This will minimise
swaying of the load during lifting. Swaying of the load may cause movement of the crane or even its turning over. This might lead
to serious injuries or even death.
Before lifting any load, make sure that once the load has been lifted the crane will not move.
Before lifting any load make sure the crane is not damaged in any manner. If it requires repairs, consult an authorised repair
workshop.
It is absolutely prohibited to adjust the safety valve of the hydraulic cylinder.
Keep the device far from sources of heat and flames, since they might damage the device or impair its functioning.
Be prudent and do not work when you are tired or under influence of medicines.
Do not modify any elements of the crane, which may have impact on the compliance of the crane with the standard indicated in
the declaration of compliance.
Have the device repaired exclusively in authorised service points, using solely original spare parts, so as to ensure the required
level of safety during work.
ASSEMBLY AND OPERATION
Assembly of the crane (I - XXII)
The crane is delivered dismantled and it is necessary to assembly it completely and carefully before the first use. The assembly
must be carried out in accordance with the pictures, making sure all the bolt connections are fastened tightly and securely. Check
the conditions of the bolt connections before each use of the crane.
Observe the following assembly instructions:
- install the wheels on the base of the crane, all the bolts and nuts must be tightened securely,
- while installing the bracket and the supports, it is required first to install the bracket to the base, not tightening the bolts com-
pletely, then install the supports and only then to tighten all the bolt connections,
O R I G I N A L
14
Maximum lifting height [mm]
1
2
GB
Weight [kg]
1830 63
1830 68
2000 70
I N S T R U C T I O N S
Application force [N] Noise L [dB(A)]
wA
≤ 200 ≤ 65
≤ 200 ≤ 65
≤ 200 ≤ 65