Package Contents - Inateck FE2010 Manual De Instrucciones

Package Contents

Inateck FE2010 X1
USB 3.0 data cable X1
Instruction manual X1
Sponge pad X1
Cautions
a: Before the removal of the data storage device, please
stop all data access and transfer to the device, so that
the storage device can be normally removed. Forced
removal may lead to damage or loss of crucial data.
b: To ensure a normal function of your hard drive, please
make sure the rated power of the hard drive is similar to
the power output of a USB port.
c: Automatic sleep and spin-down, goes into sleep mode
automatically after 30 minutes in idle state. LED flashes
each three seconds to indicate standby mode. Any
single access to the drive restores the enclosure's
operational mode. Sustainable power management and
environmental protection are ensured.
d: If your drive has been partitioned, please connect it
directly with Enclosure to use. It will be shown as "New
Disk" on computer. If not, under the premise that system
can correctly identify drives, you can use the partition
and formatting program that comes with computer
system to reformat it.
e: Due to the thickness difference of 2.5'' hard disks, a
sponge pad was attached to avoid misfit. Users are
suggested to paste the sponge to the internal side of the
shell to avoid hard drive sliding when installing a thin
disk.