GYS 052475 Manual De Instrucciones página 6

COMPOSITION
• 1 draw aligner, with pre-assembled hydraulic cylinder.
• 1 metallic part to fix on the vertical bar, to block with the
provided rod.
• 1 metallic part for the chain to pull downwards.
• 1 x 4T hydraulic pump.
• 1 pad support + 2 pads.
• 1 pulling chain + 1 x 6 hooks pull claw.
ASSEMBLY
1. Assemble the vertical bar on the horizontal bar of the
draw aligner.
2. Hook the spring on the vertical bar.
3. Screw the upper part of the cylinder on the vertical
bar.
4. Place on the horizontal bar the metallic part for the
chain to pull downwards.
5. Place the pad support, with the pad assembled on it,
on the horizontal bar of the draw aligner.
6. Depending on the use, place a pad at the extremity of
the draw aligner.
7. Place the metallic part for the pulling on the vertical
bar. Block it using the provided rod.
8. Connect the hydraulic pump on the connector of the
cylinder.
9. Assemble the chain and the 6 hook claw.
10. Pump support
A video showing the assembly of this product is available on the GYS website (www.gys.fr), in the « video » section.
6
DRAW ALIGNER EN