GYS 052475 Manual De Instrucciones página 8

PULLING CONFIGURATIONS
1.
2.
RECOMMENDATIONS
This draw aligner has been designed to pull on skin parts of the vehicle (thin sheets of steel). This product should not
be used to pull on structure elements (front shock absorbers, B pillars, sill reinforcement parts), as these elements are
made of high resistance steels, with thicker sheets of steel, and require a much higher pulling force. Any damage to
the draw aligner product following improper use, and not following these instructions will not be considered as under
guarantee.
For safety reasons, do not stand behind the vertical bar while pulling.
HYDRO PUMP
Oil Filler Screw
8
DRAW ALIGNER
Handle
Pump
Release Valve
Warning Line
Hose Coupler
Ram Coupler
EN
Hose
Ram