Instructions Of Use - GYS 052475 Manual De Instrucciones

EN
DRAW ALIGNER

INSTRUCTIONS OF USE

A video is available on our Internet website (www.gys.fr, in the « Video section ») showing the use of this product.
First of all, rings should be welded on the car body, to allow pulling.
Place a rod through the rings to allow pulling with the 6 hooks claw.
The draw aligner can be positioned in 2 ways :
If there is an edge to rest on underneath the vehicle, use the metallic
part shown left to rest on the car body and block the draw aligner
during pulling.
If there is no edge to rest on underneath the car body, use the 2 pads
provided to block the draw aligner during pulling. When working on a
sill, for example, place the first pad underneath the vehicle, on a rein-
forcement part. Place the second pad against the sill to block the draw
aligner during pulling.
Position the 6 hooks claw on the rings, and install the chain for the
pulling. Use the hydraulic pump to start the pulling.
7