Brake Cable; Recoil Starter - Electrolux JONSERED 560 Manual De Instrucciones

Product Rating Label
A
Product Number..................
Model..................................
Serial..................................
Date of Purchase...............
Place of Purchase..............
•Please Keep as Proof of Purchase•
Wheel Assembly (where necessary)
B1 B2
Handles
C1 C2
F
E
KIT 2

Brake Cable

H1 H2

Recoil Starter

J1 J2
3
ASSEMBLY INSTRUCTIONS
Please also make
a note of the date
and place of
purchase before
you return your
guarantee card.
D
G
lower handle
KIT 3
You must release
the brake by pulling
the OPC lever to the
handle before
pulling out the cord.
Your product is uniquely identified
by a silver and black product rating
label. To ensure you have full
product information when obtaining
spares or advice from one of our
approved service centres or if you
need to contact our customer
service department you should
make a note in the space provided
of the information shown in Fig A.
1. Select one of the holes in the
mounting plate and note its position,
as all four wheels will need to be
adjusted to the same position (B1).
2. Locate the fixing bolt through hole
in hub cap, wheel and selected hole
in mounting plate.
3. Turn the wheel hub in a clockwise
direction until the wheel assembly is
securely located to the deck (B2).
Lower Handles
1. If your product has Cutting Height
with levers (see Adjustment),
KIT 1
ensure the lever is at the Highest Cut
Height before following steps 2 & 3.
2. Insert each side of the lower handle
into deck as shown in Fig C1.
3. Push each side of the handle firmly
down until it is located securely into
the deck (C2).
4. Insert screw through the washer and
into holes using a pozidrive
screwdriver and tighten fully into deck
as shown in Fig C2.
Upper Handles
upper 1. The upper handle should be fixed to
handle
the lower handle using whichever
type of kit is provided (D, E and F).
Handle Adjusters fitted to product
(G)
1. Adjust handle assembly to the most
comfortable operating position and
tighten handle adjuster knob (G) on
both sides of the product.
To insert the Brake Cable
1. Insert cable into hole in OPC lever
(H1) See USE.
2. Lock into position. (H2)
3. Fit the cables to the handles with the
cable ties provided, making sure the
cables are not trapped between the
handles.
Recoil Starter
1. Disconnect the spark plug lead.
2. Pull the OPC lever to release the
brake on the engine.
3. Extend the pull cord fully (J1).
4. Locate the cord in the pull cord
guide positioned on handle (J2).
GB