Oil And Petrol - Electrolux JONSERED 560 Manual De Instrucciones

Oil and Petrol

Oil
1. Check oil level periodically and after every five
hours of operation.
2. Add oil as necessary to keep the level to the
FULL mark on the dipstick.
3. Use a good quality SAE 30 four stroke oil.
4. To fill with oil:-
a) Remove oil filler cap.
b) Fill to the FULL mark on the dipstick.
5. Change the oil after the first five hours operation
and thereafter every 25 working hours.
6. Always change the oil while the engine is warm -
but not hot - never attempt any maintenance on
a hot engine.
Petrol
1. Use fresh regular grade lead free petrol.
2. NEVER use leaded petrol.
Using leaded petrol will make the exhause
smoke and cause irreparable damage to
engines fitted with a catalytic converter.
3. Do not fill the fuel tank when the engine is hot.
4. Do not fill the fuel tank while smoking.
5. Do not fill the fuel tank while the engine is running.
6. To avoid introducing dirt into the fuel system,
wipe all grass and dirt from the petrol filler cap
before unscrewing it.
7. It is recommended that you fill the tank through a
funnel with a filter.
8. Wipe away spillages before starting.
Starting
N
Please Note:- When starting the engine for the first time, fill with oil and petrol
as described above in the Oil and Petrol section.
Priming is usually unnecessary when restarting a warm engine. However, cool
weather may require priming to be repeated.
Briggs and Stratton Engines
1. Advance throttle to FAST or RUN as
illustrated in Throttle Control section.
2. Push primer bulb (N) firmly five times
3. Following instructions in the Use - starting
and stopping section.
4. If engine fails to start after three pulls of the
pull cord, push primer bulb three times and
repeat step 3.
Starting engine (Tecumseh)
1. Move throttle control to FAST or RUN position
2. Push primer three times. Wait about two
seconds between each push. In cold weather
(55 o F/13 o C or below) push primer five times.
DO NOT USE PRIMER TO RESTART WARM
ENGINE.
5
ENGINE NOTES
Tecumseh Vantage
To fill with oil
Oil Capacity: 1 pint (0.6
litre)
a. Unscrew the oil filler
plug.
b. Remember to pour the oil
slowly.
c. Fill to the overflow point
in the oil fill hole (M1).
d. Install oil fill plug. Tighten securely.
Change oil after the first 2 hours of operation
and then after every 25 working hours.
To drain oil.
• Disconnect spark plug
and allow engine exhaust
to cool.
• Turn machine on its side
with the exhaust
uppermost.
• Remove drain plug (M2).
• Place suitable container
under product.
• Turn machine back on its wheels and the oil will
drain into the container.
Starting engine thereafter
1. Move throttle control (if fitted) to RUN or FAST
position and push primer bulb firmly three
times before starting engine. (if engine
stopped because it ran out of fuel, refuel
engine - push primer bulb three times.
M1
Tecumseh
Vantage
M2
GB