Tabla de contenido
Publicidad
Do not plug a phone jack connector into any RJ45 port. This may damage the
switch. Use only twisted-pair cables with RJ45 connectors that conform with FCC
standards.
6.
Attach the data cables and observe normal operation as indicated by the port
LEDs. Use only one Port 8, either Port 8 MDI or Port 8 MDI-X.
7.
Attach fiber optic cable with SC connectors to Port 9 and observe LEDs for
normal operation.
Auto-negotiation for transmission mode supports full-duplex only if the
connected device also negotiates for full-duplex transmission mode. Port 9
supports full-duplex operation only
You are finished with desktop installation.
Rackmount Installation
You will need a Phillips screwdriver for this installation.
Do not use power tools to perform this installation.
1.
If previously attached, remove the rubber feet and all cables and power cord from
the switch.
2.
Attach the rackmounting brackets to each side of the switch, using the screws
provided.
3.
Attach the power cord to the back of the switch.
4.
Position the switch in a standard 19-inch rack and secure the switch's brackets to
the rack using the 4 large screws provided.
5.
Plug the power cord into the power receptacle. Make sure the Power LED on the
front panel lights green.
Do not plug a phone jack connector into any RJ45 port. This may damage the
switch. Use only twisted-pair cables with RJ45 connectors that conform with FCC
standards.
Note
Note
Caution
Note
AT-FS709FC Installation Guide
7
Publicidad
Tabla de contenido
