Página 2
The information provided herein is subject to change without notice. In no event shall Allied Telesyn International, Corp. be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Allied Telesyn International, Corp.
Electrical Safety and Emission Compliance Statement Standards: This product meets the following standards U.S. Federal Communications Commissi RADIATED ENERGY Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of FCC Rules.
Table of Contents Electrical Safety and Emission Compliance Statement .......iii AT-8316F and AT-8324 Ethernet Switches ..........1 System Models ....................1 Installing the Switch ..................3 Verifying the Package Contents ..............3 Reviewing Safety Guidelines ..............3 Installing the Switch On a Desktop ............5 Installing the Switch in a Rack ..............
For information on site requirements, switch stacks, cabling specifications, network topologies, and other installation information, refer to the AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide. This guide is available on the Allied Telesyn web site at www.alliedtelesyn.com/techhome.htm. System Models Table 1 lists the system models.
Página 8
L /A L /A L /A L /A L /A L /A L /A L /A FAULT MASTER RESET AT-8316F/MT Ethernet Switch 100BASE-FX FAST ETHERNET SWITCH 100BASE-FX PORT ACTIVITY RS-232 STATUS TERMINAL PORT 100M LINK ACTIVITY L /A FULL DUP...
Verifying the Package Contents Make sure the following components are included in the switch package. If any of these items are missing or damaged, contact your sales representative. " One AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, or AT-8324 switch " Two mounting brackets "...
Página 10
Installing the Switch Warning Lightning Danger: Do not work on this equipment or cables during periods of lightening activity ! 9 Warning Power cord is used as a disconnection device: To de-energize equipment, disconnect the power cord. ! 10 Warning Electrical-Type Class 1 Equipment: This equipment must be earthed.
If you purchased an expansion module for the switch, install the module by following the instructions in either of the following manuals: AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide or AT-15/LX, AT-A15/SX, AT-A16, AT-A17, AT-A18, and AT-A19 Quick Install Guide.
Página 12
Figure 3 AT-8316F and AT-8324 Ethernet Switch Rear Panel Note For instructions on powering on an AT-8316F or AT-8324 Ethernet stack, refer to the AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide. Caution The power cord is used as a disconnect device. To de-energize equipment, disconnect the power cord.
Página 13
AT-8316F and AT-8324 Quick Install Guide RS-232 STATUS TERMINAL PORT Fault LED FAULT MASTER RESET Figure 4 Fault LED If you purchased a redundant power supply (RPS) unit for the Ethernet switch, connect the RPS unit to the R.P.S. Input connector (Figure 3) on the rear of the switch by following the directions included with the RPS system.
If you purchased an expansion module for the switch, install the module by performing the instructions in either of the following manuals: AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide or AT-15/LX, AT-A15/SX, AT-A16, AT-A17, AT-A18, and AT-A19 Quick Install Guide.
Página 15
Note For instructions on powering on an AT-8316F or AT-8324 Ethernet stack, refer to the AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide. Caution The power cord is used as a disconnect device. To de-energize equipment, disconnect the power cord.
Installing the Switch Caution If you intend to use a redundant power supply (RPS) with the switch, check to be sure that the cable with the RPS unit is compatible with the RPS Input Port on the switch. The pin assignments for the port are listed in the section “R.P.S.
AT-8316F and AT-8324 Quick Install Guide You are now ready to use the Omega management software to configure the switch. For instructions, refer to the AT-S25 Management Software User’s Guide. This guide is available on the Allied Telesyn web site at www.alliedtelesyn.com/techhome.htm. Switch LEDs Table 2 and Table 3 describe the functions of the LEDs on the Ethernet switch.
The port is operating at half-duplex. Flashing Amber Collisions are occuring on the line. For information on troubleshooting the switch, refer to the AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide. AT-S25 Software Default Setting Table 4 lists the default settings for the AT-S25 software that comes pre- installed on the Ethernet switch.
AT-8316F and AT-8324 Quick Install Guide Settings Default Telnet Access Enabled System Name None Omega Password No password assigned Omega Time-out Value 5 minutes Download Password ATS25 8324 Duplex Mode Auto-negotiating 8316F Duplex Mode Full-duplex High Port Speed Auto-negotiating Active Aging Time (MAC address table) 300 seconds Domain Name None...
There are two other manuals that you will need in order to install and operate your new Ethernet switch. The manuals are: AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide, PN 613-10813-00 AT-S25 Software Management User’s Guide, PN 613-10844-00 Both of these manuals are available on the Allied Telesyn web site at www.alliedtelesyn.com/techhome.htm.
Appendix A Translated Electrical Safety and Emission Information IMPORTANT: This appendix contains multiple-language translations for the safety statements in this guide. WICHTIG: Dieser Anhang enthält Übersetzungen der in diesem Handbuch enthaltenen Sicherheitshinweise in mehreren Sprachen. VIGTIGT: Dette tillæg indeholder oversættelser i flere sprog af sikkerhedsadvarslerne i denne håndbog.
Página 22
Translated Electrical Safety and Emission Information Standards: This product meets the following standards: U.S. Federal Communications Commission RADIATED ENERGY Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Página 23
AT-8316F and AT-8324 Quick Install Guide ! 13 CAUTION: Air vents must not be blocked and must have free access to the room ambient air for cooling. ! 14 OPERATING TEMPERATURE: This product is designed for a maximum ambient temperature of 40° degrees C. ! 15 ALL COUNTRIES: Install product in accordance with local and National Electrical Codes.
Página 24
Translated Electrical Safety and Emission Information Standarder: Dette produkt tilfredsstiller de følgende standarder. Radiofrekvens forstyrrelsesemission EN55022 Klasse A ADVARSEL: I et hjemligt miljø kunne dette produkt forårsage radio forstyrrelse. Bliver det tilfældet, påkræves brugeren muligvis at tage tilstrækkelige foranstaltninger. Immunitet EN50082-1 1997 Elektrisk sikkerhed EN60950, UL1950, CSA 950...
Página 25
AT-8316F and AT-8324 Quick Install Guide VEILIGHEID WAARSHUWING Klasse-1 laser produkt. WAARCHUWING Neit in de straal staren. WAARSCHUWINGEN MET BETREKKING TOT ELEKTRICITEIT WAARSCHUWING: GEVAAR VOOR ELEKTRISCHE SCHOKKEN Verwijder het deksel niet, teneinde ELEKTRISCHE schokken te voorkomen. Binnenin bevinden zich geen onderdelen die door de gebruiker onderhouden kunnen worden. Dit toestel staat onder GEVAARLIJKE SPANNING en mag alleen worden geopend door een daartoe opgeleide en bevoegde technicus.
Página 26
Translated Electrical Safety and Emission Information DANGER DE FOUDRE DANGER: NE PAS MANIER le matériel ou les CÂBLES lors d’activité orageuse. ! 10 ATTENTION: LE CORDON D’ALIMENTATION SERT DE MISE HORS CIRCUIT. POUR COUPER L’ALIMENTATION DU MATÉRIEL, débrancher le cordon. ! 11 ÉQUIPEMENT DE CLASSE 1 ÉLECTRIQUE CE MATÉRIEL DOIT ÊTRE MIS A LA TERRE.
Página 27
AT-8316F and AT-8324 Quick Install Guide ! 14 KÄYTTÖLÄMPÖTILA: Tämä tuote on suunniteltu ympäröivän ilman maksimilämpötilalle 40°C. ! 15 KAIKKI MAAT: Asenna tuote paikallisten ja kansallisten sähköturvallisuusmääräysten mukaisesti. Standard: Questo prodotto è conforme ai seguenti standard. Emissione RFI (interferenza di radiofrequenza) EN55022 Classe A AVVERTENZA: in ambiente domestico questo prodotto potrebbe causare radio interferenza.
Página 28
Translated Electrical Safety and Emission Information Sikkerhetsnormer: Dette produktet tilfredsstiller følgende sikkerhetsnormer. RFI stråling EN55022 Klasse A ADVARSEL: Hvis dette produktet benyttes til privat bruk, kan produktet forårsake radioforstyrrelse. Hvis dette skjer, må brukeren ta de nødvendige forholdsregler. Immunitet EN50082-1 1997 Elektrisk sikkerhet EN60950, UL1950, CSA 950 Laser...
Página 29
AT-8316F and AT-8324 Quick Install Guide AVISO Produto laser de classe 1 AVISO Não olhe fixamente para o raio. AVISOS SOBRE CARACTERÍSTICAS ELÉTRICAS ATENÇÃO: PERIGO DE CHOQUE ELÉTRICO Para evitar CHOQUE ELÉTRICO, não retire a tampa. Não contém peças que possam ser consertadas pelo usuário.
Página 30
Translated Electrical Safety and Emission Information PELIGRO DE RAYOS PELIGRO: NO REALICE NINGUN TIPO DE TRABAJO O CONEXION en los equipos o en LOS CABLES durante TORMENTAS ELECTRICAS. ! 10 ATENCION: EL CABLE DE ALIMENTACION SE USA COMO UN DISPOSITIVO DE DESCONEXION. PARA DESACTIVAR EL EQUIPO, desconecte el cable de alimentación.
Página 31
AT-8316F and AT-8324 Quick Install Guide ! 13 VARNING: Luftventilerna får ej blockeras och måste ha fri tillgång till omgivande rumsluft för avsvalning. ! 14 DRIFTSTEMPERATUR: Denna produkt är konstruerad för rumstemperatur ej överstigande 40 grader Celsius. ! 15 ALLA LÄNDER: Installera produkten i enlighet med lokala och statliga bestämmelser för elektrisk utrustning.
If there are topics you would like information on that were not covered in this guide, please photocopy this page, answer the questions and fax or mail this form back to Allied Telesyn International. The mailing address and fax number are at the bottom of the page. Your comments are valuable when we plan future revisions of this guide.
______________________________________________________________________ Detailed description (Please use separate sheet) Please also fax printouts of relevant files such as batch files and configuration files. When completed, fax this sheet to the appropriate Allied Telesyn office. Fax numbers can be found on page 31.
Address: gateway.centre.com [lowercase letters] Login: anonymous [lowercase letters] Password: your e-mail address [requested by the server at login] For Corporate or Sales Information Allied Telesyn International, Corp. Allied Telesyn International, Corp. 19800 North Creek Parkway, Suite 200 960 Stewart Drive, Suite B...