HERKULES S 390 E Manual De Instrucciones página 11

DESCRIPTION
1 Upper handles
2 Lower handles
3 Fastening knobs for upper handles
4 Collection bag
5 Safety button
6 Blade height adjusting knob
COLLECTION BAG ASSEMBLY
ASSEMBLY
BLADE HEIGHT ADJUSTMENT
Move the lever (12) forwards.
Adjust the height of the blades by turning the knob
(6) to the left to increase the working depth or to the right
to reduce it. (1 turn = 1 mm).
N.B.= make tha blades cut into the earth by about 3 mm.
Setting the working depth
Select the working depth depending upon the wear of
blades and the state of the lawn. If the motor does not
SAFETY PRECAUTIONS
the engine is running.
Before scarifying the lawn, remove all foreign objects.
While mowing, stay alert for any foreign objects which
may have been missed.
During the engine start-up or operation, the operator
shall not lift the scarificator; should this be necessary, the
OPERATION
CONNECTION V220/230 - 50 Hz
SCARIFICATION
Each year and on every lawn, moss and weeds take hold,
which cause the ground to become matted.
By scarifying, the hard surface is cut, allowing the grass
to breathe and take up nutritional substances, oxygen
and water.
Before scarifying, mow the lawn to a height of about 40
mm (1 inch).
3
EN -
Always operate with the deflector or collection bag in the correct position.
Always stop the engine before removing the collection bag or adjusting the height of cut.
Never place your hands or feet underneath the deck or into the grass discharge chute while
7 Deck
8 Cable tension relief
9 Rear deflector wall
10 Motor cover
11 Engine stop lever
12 Blade engagement lever
pull through or even stops in scarifying, the wrong working
depth has been selected.
In this case, reduce the working depth.
The motor must turn evenly.
Adjustment level per Step: 1 mm.
Adjustment level max: 10 mm
Adjustment level advised: 3 mm
equipment shall be tilted so that the blades are on the
opposite side of the operator.
Never place your hands or feet underneath the deck or into
the rear discharge chute while the engine is running.
Only use the scarificator when the lawn is dry.
March, April, and September are the best months for
scarifying.
Do this work at least once a year.
To get a nice green effect, we recommend using a fertiliser
immediately after scarification.
english