Keep Warm Function; Safety Cut-Out; Cleaning And Maintenance - Kalorik USK JK 28345 Manual De Instrucciones

Fax +32 2 359 95 50
displayed for a few seconds and the kettle will turn off
automatically.
When the kettle is off, you can check the temperature of the water
•
anytime by pressing any button on the control panel.

KEEP WARM FUNCTION

You can program the water kettle to keep a preset temperature. Set
the desired temperature as explained in the paragraph
"OPERATION" and press on the Keep warm button while the
temperature is still flashing on the display. The "Keep Warm" LED turns
on, and will keep the water warm until the kettle is lifted from its base
or shut off. The water kettle emits 2 short beeps to remind you of the
warm water.
NOTES:
Always disconnect the power supply when not in use.
•
When pouring a large quantity of hot water, pour slowly and do
•
not incline the kettle past the horizontal line to avoid burns and
injuries
The water kettle can only display the temperatures in Fahrenheit
•
degrees (°F), not in Celsius degrees (°C)

SAFETY CUT-OUT

This jug kettle is protected with an automatic safety device if
•
accidentally switched on without water.
If this happens, switch off the appliance by putting the switch in
•
OFF position and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element. This will
reset the safety device.
The kettle may then be used as normal.
•

CLEANING AND MAINTENANCE

Before attempting any cleaning operation, make sure the
•
appliance is unplugged from the supply socket and fully cooled
down.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
6
Assembly page 6/28
special instruction from Team
USK JK 28345 - 091125