Dispensing; Adjusting The Froth; Continuous Frothing Function; Automatic Cleaning - Astoria Plus 4YouTS Manual De Uso Y Mantenimiento

Plus4YouTS
6.8.2

Dispensing

Do not direct the steam towards hands or other
parts of the body. Do not touch the steam nozzles
with bare hands; use the appropriate PPE.
• Immerse the automatic steam
wand nozzle tips into the milk.
• Press the or
• Wait until the dispensing process
has been completed.
• To stop dispensing ahead of time,
press the button again or the
button.
• By holding down the
button, it is possible to extend the
steam dispensing time in addition
to the set temperature.
Keep the tips clean at all
times using a cloth dampened in lukewarm water.
Milk can be kept in the fridge for a maximum of
3-4 days.
The system has a maximum timeout of 4 minutes for when
the automatic steam wand is being used.

Adjusting the froth

6.8.3
To increase or decrease the froth consistency, turn the spe-
cific regulator (10). Turning it clockwise will decrease the
consistency, whilst turning it anti-clockwise will increase the
amount of froth.
The froth produced by the automatic steam wand
is adjusted by the factory during the machine test-
ing phase. Therefore, we recommend that you only
adjustment this if it is strictly necessary.
50 216
of
button.
or
6.8.4

Continuous frothing function

• Immerse the automatic steam
wand nozzle tips into the milk.
• Press the
• To stop dispensing, press the
button again.
6.8.5

Automatic cleaning

When the machine has been idle for 120 minutes, a 15-sec-
ond automatic nozzle cleaning cycle will be carried out.
The following message will appear on the display: "STEAM
CLEANING CYCLE". A minimum amount of steam will come
out of the nozzle.
Only leave the steam wand immersed in the milk
for the time needed to heat it.
Do not open the steam valve with the steam wand
immersed in milk while the machine is switched off.
10
button.
User Manual