Leuze CU405-2M12 Manual De Instrucciones página 11

Safety
This connection unit was developed, manufactured and tested in line with the ap-
plicable safety standards. It corresponds to the state of the art.
Intended use
The CU405-2M12 connection unit enables the connection of an RSL 410 safety
sensor to fieldbus modules with M12 connectors in accordance with the specifica-
tions of the AIDA (Automatisierungs-Initiative deutscher Automobilisten = Automa-
tion Initiative of German automobile manufacturers).
CAUTION
Observe intended use!
Ä
Only operate the device in accordance with its intended use.
The protection of personnel and the device cannot be guaranteed
if the device is operated in a manner not complying with its in-
tended use.
Leuze electronic GmbH + Co. KG is not liable for damages caused
by improper use.
Ä Download the original operating instructions for the RSL 410
safety sensor at www.leuze.com
Ä
Read this supplement and the original operating instructions for
the RSL 410 safety sensor before commissioning the device.
Knowledge of these documents is required in order to use the
equipment for its intended purpose.
NOTICE
Comply with conditions and regulations!
Ä
Observe the locally applicable legal regulations and the rules of
the employer's liability insurance association.
Foreseeable misuse
Any use other than that defined under "Intended use" or which goes beyond that
use is considered improper use.
Observe the safety notices on intended use and foreseeable misuse in the original
operating instructions for the RSL 410 safety sensor.
NOTICE
Do not modify or otherwise interfere with the device!
Ä
Do not carry out modifications or otherwise interfere with the de-
vice. The device must not be tampered with and must not be
changed in any way.
Ä
The device must not be opened. There are no user-serviceable
parts inside.
Ä
Repairs must only be performed by Leuze electronic GmbH + Co.
KG.
EN
11