Publicidad
provided.
8. Route the remaining portion of the T-Connector harness
through the vehicle wiring harness opening in the body behind
the tail light assembly opening and down under the vehicle.
Position the 4-flat connector near the center of the rear
bumper. Route the T-Connector harness ends with the green
wire to the Right (passenger) side of the vehicle and up
through the opening behind the right tail light assembly.
9. Repeat steps 4 & 5 for the right (passenger) side, using
the connector ends with the green wire.
10. Confirm correct operation with a test light or by using a
trailer. Note: All connections must be complete for the
T-Connector harness to operate.
11. Secure all wires using cable ties (provided). The
T-Connectors black box should be secured behind the left
(drivers) side tail light housing.
12. Re-install both tail light assemblies using the fasteners
removed in step 2.
Publicidad
