Friedrich SH14 Manual De Uso, Cuidado E Instalación página 16

STEP 3. Slide the cabinet into the hole far enough to allow the guide-channel of the sill plate to contact the inside wall
surface (See Figure O).
STEP 4. Drill three (3) 5/32" dia. pilot holes through holes in sill-plate into the framing and install three (3) #12 x 2" long
screws (Item #4) (See Figure O).
FIGURE O
TYPICAL INSTALLATION
Trim moulding
Screw #12A x 2" long
Use 3.
Sill plate
Guide channel
NOTE: ALTERNATE FASTENERS WHICH MAY BE USED FOR SECURING THE SILL PLATE IN THE WALL, AND THE
SUPPORT BRACKETS TO THE OUTSIDE WALL ARE NOT FURNISHED, BUT ARE AVAILABLE AT A LOCAL
HARDWARE STORE.
STEP 5. Drill two (2) 5/32" (4 mm) dia. pilot holes in each side at the locations shown (Figure O) and install four (4) #12 x
2" screws (Item #4). If the hole construction in Step 2 provides a sturdy mount with solid vertical studs, no support
brackets are required. The installation must support the weight of the unit plus an additional weight of 400 pounds
(185 kg) on the rear of the cabinet. The support brackets may be used for through-the-wall installations as shown
in Figure O, for additional suppor t.
STEP 6. If desired, trim around the cabinet on the room side with a suitable frame molding furnished by the installer (See
Figure O).
Page 16
Inside wall
Surface
MOLLY OR TOGGLE BOLT
Caulk all sides air tight
Note: Support brackets may be omitted from
through-the-wall installations if the cabinet is
secured as follows. Drill 2 holes in each side
and install 4 fasteners (2 each side).
Use #12A x 2" (51 mm) screws, toggle bolts or
expansion anchor bolts as shown in Step 5.
Support brackets (Item 1) (See note above)
Screw #12 x 2" long, use one in each bracket.
Drill 5/23 (4 mm) dia. pilot holes.
EXPANSION ANCHOR BOLT
3/8" (10 mm) slope down