Tabla de contenido
Publicidad
Installation
Analyzer serial numbers are located on the configuration
label on the analyzer rear panel, and on the calibration label
on the forward edge of the top panel.
PC system requirements
The APx500 measurement software version 4.1 and later
can be very demanding of the personal computer (PC) run-
ning the APx software.
Moderate measurement demands
Moderate measurement demands (measurement band-
widths under 90 kHz, channel counts of 2 or 1) will per-
form adequately using a PC with these minimum
specifications. Measurement demands of the APx515 typi-
cally fall within this moderate range:
• Operating system: Microsoft Windows 10 (64-bit),
Windows 8 (64-bit), or Windows 7 (64-bit).
• A multi-core processor (at least dual-core) running at a
clock speed of at least 2 GHz. Most current processors
from Intel and AMD meet these requirements.
Note: the Intel Atom processor does not meet our
minimum specification.
• At least 2 GB of RAM.
• At least 300 MB of free hard disk space.
• A CD-ROM optical disc drive.
• A USB 2.0 port; two are required for optional switcher
or DCX-127 use.
• A color monitor and a video card with at least VGA
capabilities. Video resolution of 1024 x 768 or greater
is recommended.
To learn more, view the current APx PC Minimum System
Solutions document on our Web site at www.ap.com. This
2
information will help you to determine the adequacy of a
particular PC for APx use.
Installation
To install the measurement software, insert the APx500 CD-
ROM into the optical drive on the PC and follow the
instructions in the installation dialog.
NOTE: You must have local administrator rights
to install APx500 software. Go to User Accounts
in the Windows Control Panel, or check with your
network administrator.
Running the software without instrument hard-
ware attached
NOTE: You must have standard user rights or
administrator rights to operate APx500 software.
Guest users are not supported.
You can launch the APx500 software without instrument
hardware attached. When no hardware is detected, APx500
will present you with the following dialog box:
Select "Demo Mode." APx500 will run in demo mode,
which allows you to explore the user interface but does not
enable any measurement functions. Input data shown in
Demo Mode is false data, generated for display only.
APx515 B Series Audio Analyzer: Installation
Publicidad
Tabla de contenido
