ELICA ELEKTRA Montaje Y Modo De Empleo página 17

Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent. DO NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Panel
Fig. 23
This model is equipped with a perimetric suction panel.
The panel allows to optimize the performances of the
hood.
Attention! Hold the panel with both hands when
dismantling and re-mounting in position to avoid it falling
and causing damage to people or things.
Panel maintenance
Disassembly:
1. pull out firmly (LOWER SIDE) and rotate upwards.
2. push to the left the small lever located on the right side of
the panel..
3. unhook it from the back hinges.
Cleaning:
The suction panel must be cleaned as frequently as the
grease filter, use a cloth dampened with neutral washing
liquids.
Avoid using products containing abrasives. DO NOT USE
ALCOHOL!
Assembly :
Operate inversely to disassembly.
Attention! always make sure that the panel is well fixed in its
proper place.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Fig. 9-24
CLEAN WITH TOOLS
Charcoal filter (filter version only)
Fig. 25
It absorbs unpleasant odors caused by cooking.
The charcoal filter can be washed once every two months (or
when the filter saturation indication system – if envisaged on
OR
the model in possession – indicates this necessity) using hot
water and a suitable detergent, or in a dishwasher at 65°C (if
the dishwasher is used, select the full cycle function and leave
dishes out).
Eliminate excess water without damaging the filter, then put it
in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
• Montage
Open the steam screen and remove the grease filter.
Install the carbon filter on the back of the grease filter and
fix with two rods.
Attention! The rods are included in the carbon filter
packing and not on the hood.
• To dismantle the filter act in the reverse manner.
Replacing lamps
Fig. 26
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
To replace lights, contact authorised spare part center.
17