Blackmagic Design Pocket Cinema Camera Manual De Instalación Y Operación página 43

Help
43
Replacing the Fan
Cinema Camera and Production Camera 4K each contain a fan, which is necessary for cooling. If you
detect the fan is not working, or is making a strange noise, switch off the camera and order a replacement
fan by contacting Blackmagic Design Support. You should use an anti-static strap to avoid damaging
the camera while opened.
To replace the fan:
Step 1. Switch off the camera and remove any external cables.
Step 2. Place the camera upside down on a bench, with the tripod hole facing up, and the touchsceen
facing towards you. You will see a metal panel labelled "Fan". This panel is attached to a fan
module inside the camera. Remove the four screws from this panel using a number 01 size
Phillips head screwdriver. Thread-locking fluid has been applied to the screws which will require
additional force to unscrew them. Keep the screws as you will need them again.
Gently lift the fan module up and out of the camera, taking care NOT to pull the wires that
Step 3.
connect to the inside of the camera. Accidentally pulling on these wires could cause them to
become unplugged from an inaccessible location inside the camera, which would need to be
fixed by a Blackmagic Design service center.
Locate the white plastic plug a short distance along the wires from the fan. Pull the plug apart
Step 4.
using both hands so that no stress is placed on the wires that continue inside the camera. You
can now discard the old fan module.
Step 5. Connect the white plastic plug to the wires of the replacement fan module. Reinstate the fan
module in its hole with the "Fan" label the right way up. The fan module can only be installed
in one orientation. Reinstate the four screws into the fan plate to finish replacing the fan.
Step 6. Switch on the camera and you should feel a gentle flow of air coming from the vent holes in
the fan module.