Klimatronic Heat Supreme 2000 Manual Del Usuario página 18

•
Connect the appliance to the power supply and push the on/off switch (O/I) located at the left side of the
heater to switch on the appliance. An acoustic signal sounds and the display will light up for 3 seconds,
then automatically switch to standby mode. Push the on/off switch again when you want to switch it off.
Note: You can identify the standby mode by a display that does not show any indicating lights for the
heating power/fan (
•
Day and time setting:
In standby mode, press the button „SET". The display shows the days of the week as numbers:
o
1 2 3 4 5 6 7
Use the buttons „+" and „-" to choose between the numbers. The selected day flashes. Please
press „OK" to confirm.
Example: Monday -> 1
After confirming the day, the hour indication of the clock flashes:
o
Use the buttons „+" and „-" to set the current hour and confirm with „OK". Next, the minute
indication flashes:
The display now shows the time and current day of the week.
o
•
Manual operation:
Press the on/off button
o
Temperature setting:
o
▪ Press „SET". The default temperature of 20°C flashes.
▪ Use „+" and „-" to choose a target temperature from 5-40°C. Confirm with „OK".
Note: Heating is stopped when the ambient temperature has reached the target
temperature. If the ambient temperature is 2°C lower than the target temperature,
heating will resume. If the ambient temperature is higher than the target temperature,
no heating is started.
Selection of heating power/fan:
o
▪ Press the button
1800W (
900W (
Cooling fan (
The corresponding indicating light appears on the display. Please note that the fan is
independent from the target and ambient temperature.
Open window sensor:
o
▪ You can activate the open window sensor to prevent the appliance from heating for a
longer period when a window is open. Please note that the sensor can only be used in
the manual operation. To activate the sensor, press and hold the according button for
three seconds.
▪ If the ambient temperature drops by 5°C within 10 minutes, the appliance starts a 30-
min.-countdown:
▪ Press and hold the open window sensor button again for three seconds to deactivate
the sensor.
•
Automatic operation (week program):
In the automatic operation you can set a week program to define on which days, at which times
o
and to which target temperature heating shall take place. During the week program the
appliance works with 1800W (
Week program setting:
o
▪ In standby mode press and hold the week program button for three seconds. The
indicating light
▪ The days of the week appear on the display as numbers.: 1 2 3 4 5 6 7.
Use the buttons „+" and „-" to choose between the numbers. The selected day flashes.
Press „OK" to confirm.
▪ You will now enter the hour setting for your selected day. The appliance can be
programmed between 0-24h for full hours. The hours are indicated by boxes. Each box
represents one hour:
The first box „0" represents the time 00:00 – 00:59 AM, the second box „1" the time
01:00 – 01:59 AM etc.
The selected box flashes quickly. To modify the box, press „SET". Now the box flashes
▪
/ / ).
. Set the current minutes and confirm with „OK".
on the control panel. The manual operation starts with 1800W (
. You may choose between the following modes:
)
)
)
•
After 30 minutes, if the ambient temperature is the same or lower, the appliance
switches to standby mode and the heating as well as open window sensor are
automatically deactivated.
•
If the ambient temperature is higher, the appliance continues to heat and the
open window sensor remains active.
). Other selections are not possible.
flashes until the setting is finished.
).