Scope Of Delivery; Optional Accessories; Getting Started - Proceq Pundit Live Array Pro Guia De Inicio Rapido

Scope of Delivery

Pundit Live Array Pro
Carrying case
A
Pundit array transducer
B
Proceq Live Wi-Fi module
C
Rechargeable AA NiMH Battery (Set of 6)
D
Power supply
E
Pundit Live tape measure (3x)
F
Pundit array contact tester
G
Quick start guide and product certificates
H

Optional Accessories

Dual Handle Kit
K
I
Pundit array 16
L
J
channel upgrade kit
Pundit Live tape
K
measure (10x)
4

Getting Started

Congratulations on your purchase of Pundit Live
327 30 150
Array Pro. This instrument has been manufactured
to highest Swiss quality standards. For complete
instructions
watch the tutorials in the Pundit Live app or visit
www.proceq.com/downloads.
Prepare the transducer
Step 1
Battery installation
Remove the battery pack by loosening the two screws.
327 30 370
327 30 140
WARNING!
!
Insert the six AA rechargeable batteries being sure to
observe the correct polarity.
327 30 418S
Before first use, fully charge the batteries using
the charger provided. Press the fuel gauge button
to check the charge status. 5 LEDs lit indicate a
charge of more than 80%.
Start the transducer
Press the Power button to turn the transducer
on. It takes about 20 seconds to boot up.
and safety handling information,
Step 2 Install the app
Install the Pundit Live app from the App
Store on your compatible iOS device.
Create your account in the app or on
live2.proceq.com.
Step 3 Probe verification and connection
Connect the iOS device to the
internet and launch the Pun-
dit Live app. Sign in with your
account and then tap on the
"Probe" tile. On the "Device
Information" screen, tap the
"Scan" button to begin QR
code recognition, and then follow the on-screen
instructions. A "Successful Registration" message
will appear. QR Code verification is only required
once for initial set-up. Subsequently proceed to
the iOS Wi-Fi settings to connect to the Pundit Live
Array network. The app will inform you if new
probe firmware becomes available. Perform the
upgrade by tapping on the "Probe" tile when the
probe is connected.
For detailed instructions on set-up, measuring and
handling, watch the tutorial videos by tapping on
the "Tutorials" tile on the app home screen.