Würth 1952 003 110 Manual De Instrucciones página 7

• Place the engine/clutch at the desired high utilizing an hydraulic
jack.
• Place the tool above the engine and the feet of the supports (O)
in the inner side-slats of the bonnet.
• Adjust the Fork blade (A) angle and lock the position using the
pin included (fig. 1)
• Adjust the distance between the supports using the knobs (H).
• Turn the chain (M) around a rigid element of the engine and fix
the ends to the central hooks (B).
• Fit the central support (B) on the frame (D) and screw the handle
(N) after having placed the washer, see the figure.
• Screw the handle (N) until the chain (M) is stretched but not too
much.
• Never use the chain to hoist the engine from its supports.
• Take down the hydraulic jack until the chain of the trestle is
completely stretched.
• It is advisable use also vertical trestles that can offer a further
support to the engine once adjusted at the right high.
• If there is not enough space to remove the gearbox, never take
down or hoist the engine using the handle of the device (N).
THE HANDLES (G) ARE NOT SUITABLE TO HOIST AND
TAKE DOWN LOADS.
7