CAMP SPEED COMP Manual De Instrucciones página 15

The helmet marked EN 1077 / B (see Tab.A) is intended to be used for the protection of the head against the
risk of impacts following falls of the user during the practice of alpine skiing and snowboarding.
USE
Choice of the helmet: the helmet should be adapted to the intended use, as shown in chart A.
Adjustment: in order to protect you, your helmet should be correctly fit. Before each use, adjust the helmet as follow:
1)
Headband adjustment [2]:
• Adjust the headband at its maximum extension.
• Put the helmet on the head.
• Tighten the headband according your head size, by the headband adjustment as shown in fig.1.
2)
Chin straps [3] adjustment and closing (fig.2).
3)
Speed Comp: paddings are integral parts of the helmet; in order to guarantee an adequate protection, the helmet
must not be used without paddings or in case they are damaged. Spare front padding supplied together with the
helmet can be replaced by the user depending on the dimensions of his/her head (fig.4).
4)
Control: check the right helmet fitting by moving your head up and down, left and right: the helmet should stay in the
original position.
Headlamp fixing: The headlamp is fixed to the helmet by inserting the elastic band in the fixing device [5] (fig.3).
REVISION
In addition to the normal inspection required before, during and after each use, this product must be inspected by a
skilled person every 12 months, starting from date the product is first used; this date and the subsequent checks must
be recorded on the product's life sheet: keep this literature for inspection and reference for the life of the device. Check
the legibility of the product's markings.
In case of one of the following defects are present, the product should be withdrawn from service immediately:
• local deformation of the shell [1]
• cracks on the outer or inner surface of the shell [1]
• defective riveting
In case of one of the following defects, the defective part should be changed (tab.B):
• incorrect functioning of the closing system [4]
• incorrect functioning of the headband adjustment system [2]
• absence or bad condition of padding [6]
• cut, tears and abrasions of stitching or straps.
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service immediately.
Each product in the safety system can be damaged during a fall and must be always inspected before use it again. Do
not continue to use a product after a major fall because a damage may have occurred, even no external signs are
visible.
LIFETIME
The lifetime of the product is 10 years from the date the product is first used and (taking storage into consideration) in
any case cannot exceed the end of the twelfth year from manufacturing (i.e. manufacture year 2018, lifetime until end of
2030, or 10 year from the date of first use, whichever comes first). The lifetime is understood to be in the absence of
causes which would place the product out of order with the condition that periodic inspections are carried out at least
once every 12 months starting from the date the product is first used and the results are recorded on the life sheet of the
product.
The following factors can reduce the lifetime of the product: intense use, damage to components of the product, contact
with chemical substances, high temperatures, tears and abrasions, violent impacts, failure to maintain as
recommended. If a product is suspected to be no longer safe and reliable, replace the product or contact C.A.M.P. or the
distributor before continuing use.
TRANSPORTATION Protect the product from risks such as those detailed above.
13