Using A Mains Adapter - ProMed PBW- 5.2 Instrucciones De Empleo

OPERATING THE UNIT
As soon as this symbol is illuminated, the button cell battery must be exchanged immediately.
If the 4 AA batteries are charged sufficiently, this is indicated by the symbol
state display (11) of the device. If the button cell battery is too low, the symbol
message "E6" appear on the battery state display (11). If this happens, the batteries must be
exchanged immediately, otherwise the device will yield false measurement results.
Caution:
1. Remove the batteries if the device is not in use for long periods of time.
2. Do not mix old and new batteries or different types of batteries.
3. Warning: If batteries leak and come into contact with the skin or eyes, wash immediately with
copious amounts of water.
4. Batteries must be handled by an adult. Keep batteries out of the reach of children.
5. Only batteries of the same or equivalent type are recommended.
6. Using rechargeable batteries (accumulators) is not permitted.
7. Remove exhausted batteries from the unit.
8. Dispose of batteries safety according to battery manufacturer's instructions.
9. Do not use batteries that are past their expiry date.
DE

Using a mains adapter

The device can also be operated with a mains adapter. Make sure that the adapter is permitted
for use with medical products and meets the following technical requirements; output voltage:
EN
6VDC, output current: 600mA, mains barrel connector: plus internal, external diameter 5.5mm
internal diameter 2.1mm. You can always purchase a tested mains adapter from Promed
Please note:
FR
If a mains adapter and rechargeable batteries are used at the same time, the rechargeable
batteries will not be recharged. Rechargeable batteries must always be recharged in a separate
charging device.
IT
Please note:
If, during a measurement, the electricity supply is interrupted or the battery status display (11)
ES
lights up, then the measurement absolutely must be repeated.
Connection of the upper arm arm cuff
NL
In order to connect the upper arm arm cuff (H) to the device, insert the tube connecting piece (G)
into the tube connection (F). While doing this, do not use excessive force to insert the connecting
piece in the device.
RU
PL
SE
FI
24
in the battery
and the error