Using The Memory Function - ProMed PBW- 5.2 Instrucciones De Empleo

OPERATING THE UNIT
2. Measuring without saving the results (Guest Mode)
If, in addition to the usual users, one or several other persons want to use the system, it
is sensible to use this mode to avoid falsifying history data. In this mode, the measuring
process is the same as described above with the exception that for starting or interrupting
a measurement not one of the START / STOP buttons must be pressed, but rather both at
the same time. This makes it possible to measure without saving the measurement results.
Schematic figure of the blood pressure analysis display and the symbols displayed during
measurement.
inflating process

Using the memory function

The device has a memory in which 120 measurements can be saved per user. Every time
a measurement is finished, the device automatically saves blood pressure and pulse rate.
1. Reading the measured average value
To display the average blood pressure of the past 3 measurements, press the START /
STOP button User 1
which user you are, and hold it down for 2 seconds. After you have read the values, you
can switch off the device by pressing the same user button again and holding it down for
2 seconds.
2. Reading all measurement results in the memory
To display all measurement results stored in the memory, press the START / STOP button
User 1 (A) or the START / STOP button User 2
are, and hold it down for 2 seconds. By pressing the corresponding user button again, all
measurement values stored in the memory are displayed (the most recent result is shown first
and the first measurement result is shown at the end).
After you have read the values, you can switch off the device by pressing the same user
button again and holding it down for 2 seconds.
Clearing all data in memory
To delete all the data of a user, press the START / STOP button User 1
/ STOP button User 2
2 seconds.
Now press both user buttons and hold them down for 2 seconds. "CL" appears on the
display.
inflating
(A) or the START / STOP button User 2
(B), depending on which user you are, and hold it down for
deflating
measuring process
(B), depending on which user you
29
( B), depending on
(A) or the START
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI