Before The Measurement - ProMed PBW- 5.2 Instrucciones De Empleo

OPERATING THE UNIT
Setting the alarm clock
To select "Alarm 1" or "Alarm 2", press the alarm set button
Hold the alarm set button
settings mode for the wake-up time. The alarm clock symbol
flashes on the display.
To set the desired wake-up time, press the time set button
hours flash on the display showing value "00".
- Every time you press the START / STOP button user 1
increase the value by 1. Every time you press the START / STOP button
User 2 (B), you decrease the value by 1.
- By pressing the time set button
the device moves on to the minute setting. On the display, the minutes
flash showing the value "00".
Every time you press the START / STOP button user 1
increase the value by 1. Every time you press the START / STOP button
User 2 (B), you decrease the value by 1.
DE
By pressing the time set button
EN
the device leaves the setting mode.
The alarm clock symbol
FR

Before the measurement

IT
Before you carry out a blood pressure measurement you should remain entirely calm for 5 - 10
minutes, not eat, not drink any alcohol, not smoke, not do any sport and not bathe. All of these
factors influence the measurement result. Remove items of clothing that are tight on your upper
ES
arm. Always measure on the same arm (normally left). Carry out the measurement regularly at
the same time of day, because blood pressure changes during the day.
NL
Factors that can lead to incorrect measurements
Everything that supports the arm during measurement can increase the blood pressure. Make
sure that you are in a comfortable position and do not move your arm during the measurement.
RU If necessary, you can place a cushion under the arm to be measured If the arm artery is lower
or higher than the heart this will lead to an incorrect measurement result.
Please note:
PL
Only use arm cuffs that are permitted by the manufacturer and clinically approved!
A loose arm cuff or a defective arm cuff in which the bladder is exposed causes incorrect
measurement values.
SE
In the case of repeated measurements, blood accumulates in the arm arteries, which can lead to
incorrect measurement values.
Continuous blood pressure measurements should be repeated no sooner than after a 1 minute
FI
break.
Here it is important that the arm is held upward to ensure that the accumulated blood can
flow away.
(D) down for 2 seconds to switch to the
(C), you confirm your setting and
(C), you confirm your setting and
(3) is now illuminated on the display.
26
(D).
(3) now
(C). The
(A), you
(A), you