Kalorik USK SIT 25803 Manual De Instrucciones página 7

Figure1: Take the main bracket with ironing
board part from package. First insert the pole
fixing nuts (part 15) into each pole then slide the
bracket into the holes at the back of the front
cover (Part 18). Then push the two fixing nuts
down to secure the bracket firmly.
Figure 2: Inset the 2 shafts of the tilted bracket
into the front holes of the front cover, by
positioning the black pegged parts into correct
position. Push down to fix firmly.
Figure 3: Clip on the two shaft covers (part 24).
Figure 4: Adjust the tilted bracket against the
main bracket, align the holes in the two
brackets, and then use the metal screws and
nuts to secure the two brackets together using
part 26. Clip on screw covers. Please use the
screws that do not have a plastic washer
Figure 5: Take the two parts of the ironing board
and clip them together.
Figure 6: Support the ironing board as shown by
inserting the diagonal bar into the clamp.
Figure 7a: The bolts to secure the diagonal
support brackets have a plastic washer. This
washer must be placed between the two
brackets.
Figure 7b: Sort into pairs and clip on the screw
covers. The cover with a hole in it is placed on
the side where the bolt is, sothat the bolt fits
inside the hole.
7
USK SIT 25803 - 080425