Zyxel SSL 10 Guia De Inicio Rapido página 3

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
2 Initial Hardware Connection
1 Use an Ethernet cable to connect the WAN port to a broadband modem or gateway.
2 Use an Ethernet cable to connect a management computer to a LAN port.
3 Use the included power adaptor to connect the POWER 12V port on the rear panel to a
power source.
After you have connected the power and turned on the power source, check the LEDs. The
PWR LED turns on. The SYS LED blinks while performing system testing and stays on
when the testing is successful. The WAN and LAN LEDs turn on when the corresponding
ports are connected.
If none of the LEDs turn on when the power is connected, check the port
connections and make sure the power source is turned on.
3 Access the Web Configurator
Follow the steps below to log into the web configurator through a LAN port and configure
the ZyWALL. You must use Internet Explorer 6.0/Netscape 7.0 or later versions.
1 Make sure your computer is set to receive an IP address from the ZyWALL.
2 Launch your web browser. Enter 192.168.1.1 (the
ZyWALL's default LAN IP address) as the
address.
1
2
ENGLISH
3
3

Publicidad

Tabla de contenido
loading

Tabla de contenido