Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7 - PERSONAL PIN CODE
As the PIN code enables access to the system, it should not be
left in the unattended vehicle as it can be used to deactivate
the system or to add new radio controls without authorization.
To change your PIN code, follow this simple procedure:
1. Disarm the system using the radio control.
2. Turn the ignition key "on".
3. Open a door and the bonnet and keep them open during
the programming phase.
4. Press key "A" on the radio control until the turn indicators
flash to indicate that you have accessed the programming
function.
5. Enter the old PIN code:
•
Press the button on the emergency panel for the number of
times corresponding to the first digit of the new PIN code.
The LED will flash fast each time you press the button.
•
A longer pause will be interpreted by the system as the
number having been fully entered and will be signalled by
a long flash from the LED and a beep from the buzzer.
Proceed in the same way for the other digits.
•
Enter the old PIN code again.
24
06DE2142E.pmd
24
6. Enter the new PIN code:
•
Turn off the ignition once the fourth digit has been entered.
•
Enter the PIN code again. If the system ascertains that the
entered code matches the programmed one, the code will
be memorized. This is signalled by a 3 s flash from the turn
indicators and the LED. Close the door to quit the procedure
at any time. The old PIN code will not be modified in this
case.
Personal pin code - BRIDGE 4100
11/02/2008, 11.15
Publicidad
Tabla de contenido
