Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8 - MAINTENANCE AND TROUBLE SHOOTING
8.1 - Radio control battery low
If the LED flashes for a brief time or in an irregular way when one
of the buttons is pressed, this means that the battery is low and
must be replaced.
1. To change the battery, open the shell of the radio control by
levering in the zone shown in the figure.
2. Remove the battery as indicated.
3. Wait about 10 s.
4. Fit the new battery, taking care to only touch its sides with
the fingers. Comply with the polarity as shown in the figure.
5. Close the battery shell and press key "A" on the radio control,
make sure that the system responds. Conduct tests near to
the vehicle.
6. Dispose of the old battery in the relative containers provided
for this purpose.
7. If both the radio controls are lost, you will still be able to
disarm the system in an emergency.
Refer to the emergency override procedure (chapter 6).
BRIDGE 4100 - Maintenance and trouble shooting
06DE2142E.pmd
25
8.2 - Trouble shoting
f
A Solution:
The radio control battery may be flat (chapitre 8 page 25).
B Solution:
Follow the emergency procedure to disarm the system
(chapter 6 page 23) and then contact your dealer.
f
A Solution:
If ultrasonic volumetric trigger is shown, check that windows,
sunroof and air vents are closed and that no moving objects
are in the vehicle.If the problem persist contact your dealer.
B Solution:
If direct contact trigger (doors, boot and bonnet opening) is
shown, one of the switches requires adjustement.Contact
your dealer.
11/02/2008, 11.15
y
pp
25
Publicidad
Tabla de contenido
