Beurer BARBERS CORNER HR 4000 Instrucciones De Uso página 23

Switch the device off before attaching/removing a comb
attachment.
• To attach a comb attachment, place it on the trimmer
attachment or the slim contour blade attachment from
above as shown. Ensure that the comb attachment clicks
securely onto the clips for the comb attachment on the
sides.
• To remove a comb attachment, carefully release the attachment from the
clips for the comb attachment with your fingers and pull the comb
attachment up and off the trimmer attachment or the slim contour blade
attachment.
Cutting/styling the beard
Note
Before starting the application, comb your beard in the direction of growth.
1. Select the comb attachment depending on desired beard length.
2. Place the selected comb attachment on the trimmer attachment or the
slim contour blade attachment.
3. Select your desired cutting length using the
slider on the relevant comb attachment.
4. Press the ON/OFF button
5. To style your beard, start from the ear. Work from there down to your chin.
Style one side first, then the other.
6. When you are finished, press the ON/OFF button
device.
Note
If you wish to cut your beard very short (less than 2.5 mm), you can use the device without a comb
attachment.
Shaving/trimming precise contours
With the comb attachment for the slim contour blade you can shave/trim particularly precise
contours (for example for the sideburns).
1. The comb attachment for the slim contour blade can only be used with
the slim contour blade attachment. To do this, attach the slim contour
blade to the device.
2. Now place the comb attachment for the slim contour blade on the slim
contour blade attachment .
3. Select your desired length (1, 3, 5 mm) using the slider on the comb at-
tachment for the slim contour blade.
to switch on the device.
23
to switch off the