Sanus VISIONMOUNT MF202 Instrucciones De Montaje página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
3
Solid Concrete and Concrete Block Mounting
[15]
[14]
8
[02]
75 mm
(3 in.)
[02]
[15]
Level wall plate [02] and mark the hole locations.
CAUTION:
Avoid potential personal injuries and
property damage!
Mount the wall plate [02] directly onto the concrete
surface.
Minimum solid concrete thickness: 8 in.
Minimum concrete block size: 8 x 8 x 16 in.
F
OR ASSITANCE IN DETERMINING WALL PLATE LOCATION
F
INDER AT SANUS
Drill pilot holes as illustrated
CAUTION:
To avoid potential injuries or property
damage:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.)
using a 10 mm (3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
Insert anchors [16]
CAUTION:
To avoid potential injuries or property
damage be sure the anchors [16] seat fl ush with the
concrete surface.
[16]
Tighten the lag bolts [14] only until the washers [15] are
pulled fi rmly against the wall plate [02].
CAUTION:
Improper use could reduce the holding
power of the lag bolt. To avoid potential injuries or
property damage DO NOT over-tighten the lag bolts [14].
13 mm
10mm
(1/2 in.)
(3/8 in.)
,
H
SEE
EIGHT
.
.
COM
6901-002093 <01>

Publicidad

Tabla de contenido
loading

Tabla de contenido