Ryobi BID-1801M Manual De Utilización página 9

GB
F D
GENERAL SAFETY RULES
Maintain power tools. Check for misalignment or
■
bindling of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. Properly
■
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc.,
■
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from intended could result
in a hazardous situation.
BATTERY TOOL USE AND CARE
Ensure the switch is in the off position before
■
inserting battery pack. Inserting the battery pack
into power tools that have the switch on invites
accidents.
Recharge only with the charger specified by the
■
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
Use power tools only with specifically designated
■
battery packs. Use of any other battery packs may
create a risk of injury and fire.
When battery pack is not in use, keep it away
■
from other metal abjects like paper clips, coins,
keys, nails, screws, or other small metal objects
that can make a connection from one terminal to
another. Shorting the battery terminals together may
cause burns or a fire.
Under abusive conditions, liquid may be ejected
■
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts
eyes, additionally seek medical help. Liquid ejected
from the battery may cause irritation or burns.
SERVICE
Have your power tool serviced by a qualified
■
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
E I P NL S DK N FIN GR
English
INSTRUCTIONS FOR SAFE HANDLING
Make sure that the tool is only connected to the
■
voltage marked on the name plate.
Never use the tool if its cover or any bolts are
■
missing. If the cover or bolts have been removed,
replace them prior to use. Maintain all parts in good
working order.
Always secure tools when working in elevated
■
positions.
Never touch the blade, drill bit, grinding wheel or
■
other moving parts during use.
Never start a tool when its rotating component is in
■
contact with the work piece.
Never lay a tool down before its moving parts have
■
come to a complete stop.
ACCESSORIES: The use of accessories or
■
attachments other than those recommended in this
manual might present a hazard.
REPLACEMENT PARTS: When servicing use only
■
identical replacement parts.
SPECIFICATIONS
Bit shank size
Switch
Max. torque
Voltage
Battery (Not included)
No load speed
Blows per minute
Charger type (Not included)
DESCRIPTION
1. Bit holder
2. Bit storage
3. Switch
4. Forward/Reverse Selector w/ centre lock
5. Reverse
6. Forward
OPERATION
APPLICATIONS
Use only for the purposes listed below.
Fastening / removing screws and bolts
■
6
H CZ RUS RO PL
1/4 in. (6.35 mm)
Variable speed
135 Nm
18 V
BPP-1817M/BPP-1815M
0-2400 min
3000/bpm
BC-1800/BC-1815S
SLO HR TR
-1